Generate Electricity



Click Here for E-Book Details



Click Here for E-Book Details

Generate electricity? There are several ways to generate electricity. There are "thermal" methods like coal, oil, natural gas, peat, biomass - in all these cases, the energy that is trapped in the form of carbon (found in the ground in the form of fossil fuels) is released by heating the carbon. The problem, as we all know too well, is that the breakdown of carbon through burning it is the by product of gases such as carbon dioxide, a main contributor to global warming. But that is not all. When we burn carbon, there are other pollutants that are released into the atmosphere like sulphur dioxide and nitrous oxide. These chemicals are the principal contributors to acid rain.

We also generate electricity by non-fossil fuel methods by using uranium in nuclear "reactors" to create enough heat to boil water, which in turn produces large quantities of high pressure steam. This steam turns a turbine which turns a generator that manufactuers electic power.

There are renewable energy choices to generate electricity, by converting solar and wind energy into power. In any case dependable power generation, transmission and distribution is critical for providing heat, light and power for human activities. Electric power has been generated for the purpose of powering human technologies for at least 120 years from various sources of potential energy. The first power plants were run on wood, while today we rely mainly on oil, natural gas, coal, hydroelectric and nuclear power and a small amount from hydrogen, solar energy, tidal harnesses, wind generators, and geothermal sources.

Methods To Generate Electricity

Rotating turbines attached to electrical generators produce most commercially available electricity. Turbines may be driven by using steam, water, wind or other fluids as an intermediate energy carrier. The most common usage is by steam in fossil fuel power plants or nuclear power plants, and by water in hydroelectric dams. Alternately, turbines can be driven directly by the combustion of natural gas or oil. Combined cycle gas turbine plants offer efficiencies of up to 60%. They generate power by burning natural gas in a gas turbine and use residual heat to generate additional electric power from steam. Wind turbines create power by using the wind. Solar updraft towers use wind that is artificially produced inside the chimney by heating it with sunlight. Solar parabolic troughs and solar power towers concentrate sunlight to heat a heat transfer fluid that is used to produce steam to turn a turbine.

Small power generators are often powered by reciprocating engines burning diesel, biogas or natural gas. Diesel engines are often used to generate electricity, usually at low voltages. Biogas is often combusted where it is produced, such as a landfill or wastewater treatment plant, with a reciprocating engine or a microturbine, which is a small gas turbine.

Subscription

 
Training Courses

2-Day LV-MV-HV Electrical Safety Training

  • May 6-7, 2015 - Edmonton, AB
  • May 11-12, 2015 - Mississauga, ON
  • September 15-16, 2015 - Edmonton, AB
  • September 21-22, 2015 - Mississauga, ON
  • September 23-24, 2015 - St. Johns, NL

1-Day Arc Flash/Electrical Safety Workshop

  • May 5, 2015 - Richmond, BC
  • May 6, 2015 - Edmonton, AB
  • May 8, 2015 - Winnipeg, MB
  • May 11, 2015 - Mississauga, ON
  • May 13, 2015 - St. Johns, NL
  • September 14, 2015 - Richmond, BC
  • September 15, 2015 - Edmonton, AB
  • September 17, 2015 - Winnipeg, MB
  • September 21, 2015 - Mississauga, ON
  • September 23, 2015 - St. Johns, NL

Generators and Standby Emergency Power

  • May 11-12, 2015 - Richmond, BC
  • May 13-14, 2015 - Edmonton, AB
  • May 20-21, 2015 - Mississauga, ON

1-Day HV Electrical Safety Workshop

  • May 12, 2015 - Mississauga, ON
  • September 16, 2015 - Edmonton, AB
  • September 22, 2015 - Mississauga, ON
  • September 24, 2015 - St. Johns, NL

Canadian Fire Alarm System Training

  • June 1-2, 2015 - Richmond, BC
  • June 3-4, 2015 - Edmonton, AB
  • June 8-9, 2015 - Mississauga, ON
  • June 10-11, 2015 - St. Johns, NL

2015 Electrical Code Update Training

  • September 8-9, 2015 - Victoria, BC
  • September 10-11, 2015 - Richmond, BC
  • October 5-6, 2015 - Edmonton, AB
  • October 7-8, 2015 - Calgary, AB
  • October 13-14, 2015 - Winnipeg, MB
  • October 15-16, 2015 - Mississauga, ON

Electrical Testing and Commissioning Industrial Power Systems

  • October 19-20, 2015 - St. Johns, NL
  • October 21-22, 2015 - Mississauga, ON
  • October 26-27, 2015 - Winnipeg, MB
  • October 28-29, 2015 - Edmonton, AB

Electrical Grounding and the 2015 Canadian Electrical Code

  • November 30-December 1, 2015 - Mississauga, ON
  • December 2-3, 2015 - Winnipeg, MB
  • December 7-8, 2015 - Edmonton, AB
  • December 9-10, 2015 - Richmond, BC
 
Affiliates
 
Featured Product

S&C IntelliRupter® PulseCloser

S&C Electric Company
S&C's IntelliRupter PulseCloser is a breakthrough in distribution system protection.
more...
 
Advertisement
 
Latest Buyer's Guide Companies
Sign Up Today and Receive Our FREE E- Newsletter

E-newsletter service - Exciting industry trends, technical developments, product information, forums and electrical training courses.